module lfsr_tb(); reg clk_tb; reg rst_tb; wire [3:0] out_tb; reg hard_orig_ok; reg [3:0] hard_prev; integer hard_err = 0; LFSR DUT( .out(out_tb), .clk(clk_tb), .rst(rst_tb) ); initial begin clk_tb = 0; rst_tb = 1; #15; rst_tb = 0; #200; // $display("Failed: out=%b (expected 1101)", out_tb); hard_orig_ok = (out_tb == 4'b1101); // additional check (clk rises at 5, 15, ..., 215, 225, ...): every-cycle sequence, then a mid-run reset. #3; // t=218, mid-cycle hard_prev = out_tb; repeat (20) begin #10; // one rising edge later if (out_tb !== {hard_prev[2:0], ~(hard_prev[3] ^ hard_prev[2])}) begin hard_err = hard_err + 1; $display("HARD %0t: out=%b after %b (expected %b)", $time, out_tb, hard_prev, {hard_prev[2:0], ~(hard_prev[3] ^ hard_prev[2])}); end hard_prev = out_tb; end rst_tb = 1; // t=418: rst high across the edges at 425 and 435 #10; if (out_tb !== 4'b0000) begin hard_err = hard_err + 1; $display("HARD %0t: out=%b after an edge with rst=1 (expected 0000)", $time, out_tb); end #10; if (out_tb !== 4'b0000) begin hard_err = hard_err + 1; $display("HARD %0t: out=%b while rst=1 (expected 0000)", $time, out_tb); end #2 rst_tb = 0; // t=440, mid-cycle #8; // t=448 hard_prev = 4'b0000; repeat (16) begin hard_prev = {hard_prev[2:0], ~(hard_prev[3] ^ hard_prev[2])}; if (out_tb !== hard_prev) begin hard_err = hard_err + 1; $display("HARD %0t: out=%b after reset (expected %b)", $time, out_tb, hard_prev); end #10; end if (hard_orig_ok && hard_err == 0) begin $display("=========== Your Design Passed ==========="); end else begin $display("=========== Failed ==========="); end $finish; end always begin #5; clk_tb = ~ clk_tb; end endmodule