source_documents/0130153.txt

Brake Electronic Control Unit (ECU), Reprogramming (MID136) VN, VHD, VAH, VT
FSB 513-001, Brake Electronic Control Unit (ECU), Reprogramming (MID 136)

Certain VOLVO VN, VHD, VT, and VAH trucks equipped with the basic ESP package (ZMX-A1X), and built between January 1, 2010 and November 9, 2014, may activate an MID 136 Anti-Lock Brake System (ABS) SID 66 FMI 7 or Bendix DTC 20-8 code without any component failures, mechanical failures, or system mis-wires. The MID 136 code is due to an ABS Electronic Control Unit (ECU) threshold setting. Follow the Brake ECU (MID 136) repair and reprogramming steps outlined in this Field Service Bulletin (FSB).

Repair, Reprogramming Procedure
	You must read and understand the precautions and guidelines in Service Information, group 50, "General Safety Practices, Wheel Brakes" before performing this procedure. If	you are not properly trained and certified in this procedure, ask your supervisor for training before you perform it.
	NOTE: Information is subject to change without notice. Illustrations are used for reference	only and can differ slightly from the actual vehicle being serviced. However, key components addressed in this information are represented as accurately as possible.
	1. Park the vehicle on a flat and level surface.
	2. Apply the parking brake.
	3. Place the transmission in neutral or park.
	4. Install the wheel chocks.
	5. Download the latest Bendix VCP file to the Premium Tech Tool (PTT) laptop.
	Note: Follow the screen captures from the Truck Dealer Portal to locate the latest VCP file and download instructions.
	6. Reprogram the ABS (MID136) ECU. Note: Follow the on screen prompts until the programming is complete.
	7. Verify proper operation after reprogramming is complete.
	8. Remove the wheel chocks.

Reimbursement

	This repair may be eligible for reimbursement if a product failure was experienced within time and mileage limits of the applicable Warranty coverage. Reimbursement is obtained via the normal claim handling process.
	
	Claim Type (used only when uploading from the Dealer Bus. Sys.) for UCHP Reimbursement is "W".
	Claim Type (used only when uploading from the Dealer Bus. Sys.) for eWarranty Reimbursement is "W".
	Labor Code for UCHP Reimbursement is "None".
	Labor Code foreWarranty Reimbursement is "None".
	Primary Labor Code (Brake Electronic Control Unit (ECU), Reprogramming, MID 136) for UCHP Reimbursement is "5139-22-09-01 0.4 hrs.".
	Primary Labor Code (Brake Electronic Control Unit (ECU), Reprogramming, MID 136) for eWarranty Reimbursement is "51301-2-00 0.4 hrs.".
	Causal Part for UCHP Reimbursement is "20824479".
	Causal Part for UCHP Reimbursement is "20824479".