Update README.md

README.md

@@ -1,6 +1,6 @@
 Main protocol
 
-Performer: Hamza
+Performer: Hamza \
 Purpose / Hypothesis: To see pump height effect on signal.
 
 Needle size: 22G
@@ -16,9 +16,9 @@ Phantom setup: Foam wrapped around tube. Both wet and dry foam used.
 
 Extended:
 
-Pump was running at 22 rpm .Pattern box used for stable tube and known patter and distance from tube. 3 different height used. Needle holder and rpi was at another table in order to have no contact with phantom expect needle.
-Table ---> Pump output same level as phantom input
-1st Shelf ---> Pump output was 35 CM higher then phantom input
+Pump was running at 22 rpm .Pattern box used for stable tube and known patter and distance from tube. 3 different height used. Needle holder and rpi was at another table in order to have no contact with phantom expect needle. \
+Table ---> Pump output same level as phantom input \
+1st Shelf ---> Pump output was 35 CM higher then phantom input \
 2nd Shelf ---> Pump output was 75 CM higher then phantom input 
 
 
@@ -44,7 +44,7 @@ Table level
 
 We used 2 different point on pattern. 5G cell and abovetube. With 5G cell we had 3 different amount of needle shaft inside foam. 1cm , 2cm and 3cm mean how many cm of needle shaft was inside of foam during recording. For abovetube point we used 2 different size which were 1 cm and 2 cm.
 
-Filename meaning:
+Filename meaning: \
 5G_1CM_Table_Dry_foam_22g_Chiba_M.4.3.2_2025-09-24_12.49.17
 
 position-depth of the needle shaft inside foam-level of pump-phantom-needle gauge-needle type-sensor-type_timestamp